|
 |
| |
 |
New Product |
Total 8 items |
 |
|
 |
|
| 971 Serials Lights - Waterproof |
*Suitable for Marine & Vehicle
*Easy to install & Easily relearning Remote Unit
*Wide Range Rotation movement.
*Dual Function Control with Wire Control & Remote Control
*IP 66;CE;FCC Approved,Up & Down 120 Degree / Left & RIght 420 Degree. |
 |
|
| |
 |
|
| 970 Serials Lights - Waterproof |
*Suitable for Marine & Vehicle
*Easy to install & Easily relearning Remote Unit
*Wide Range Rotation movement.
*Dual Function Control with Wire Control & Remote Control
*IP 66;CE;FCC Approved,Up & Down 120 Degree / Left & RIght 420 Degree. |
|
|
| |
 |
|
| OS022 - Easy-Go Keyless Entry Car Alarm System |
*EASY-GO Keyless Entry Car Alarm System.
*WITH DYNAMIC IMMOBILIZER & SMART ANTI-HIJACK.
SYSTEM FEATURES:
*1).AUTO-UNLOCK
*2).DYNAMIC IMMOBILIZER
*3).SMART ANTI-HIJACK
*4).PASSIVE LOCK
*5).AUTOMATIC RE-LOCK
*6).SMART TRANSPONDER LOW-BATTERY WARNING:
*1.AUTO-UNLOCK
The system UNLOCKS the vehicle when the user is approximately 1 - 3 meters away and trigger waves are sent to the transponder to confirm user¡¦s presence. 2 seconds after the system is UNLOCKED, the vehicle enters immobilizer Mode.
*2.DYNAMIC IMMOBILIZER
The Immobilizer function will be automatically disabled when the system performs Hand-Shake confirmation with the transponder upon inserting the key and turning ON the ignition. The vehicle CANNOT be started with just the key as the transponder must be present as well when attempting to start the vehicle.
*3.SMART ANTI-HIJACK
When Anti-Hijack Mode is set to ON, if any doors are opened and closed anytime after Ignition ON, the system will check-in with the transponder after 2 minutes. If the transponder is not present after 60 consecutive checks (approx. 30 seconds), the system enters Anti-Hijack Mode, activating Starter Disable or Petroleum Pump Disable depending which is installed.
* The use of Starter Disable or Petroleum Pump Disable is recommended instead of Engine Block Disable
*4.PASSIVE LOCK
While in Immobilizer Mode, whenever the vehicle doors are opened and closed, the system will check with the transponder and LOCKS the vehicle when it is not in range. * If the user is going to work/stay around the vehicle for an extended amount of time, it is recommended to turn off all Easy-Go features temporarily in order to avoid unnecessary drain of transponder battery (see below)
*5.AUTOMATIC RE-LOCK
The system will Re-LOCK the vehicle if 1 of 2 conditions applies: 1) The user enters and leave the Detection Zone without opening the doors; 2) The user opens and closes the doors without turning on the ignition and leave.
*6.SMART TRANSPONDER LOW-BATTERY WARNING:
When low battery, press for arm the system. The parking light will flash three times.
After horn chirps once and parking flash once.
When pressing disarm, parking light will flash 5 times after flash twice.
SYSTEM LEARNING & CONFIGURATION
TRANSPONDER LEARNING:
*1.Insert the key and turn to IGNITION.
*2.Press and Hold Override Switch for 5 seconds, LED stays solid ON parking light indicating Learning Mode.
*3.Press the transponder button.
*4.Parking light flashes ONCE indicating transponder learned, LED then stays on solid.
*5.Repeat Step 3 until all transponders are learned by the system (Maximum of 4 transponders can be learned).
*6.The system exits Learning Mode after 10 seconds, to exit at any time, turn the IGNITION to OFF.
USER PROGRAMMABLE FUNCTIONS:
*1.Insert the key and turn to IGNITION.
*2.Press Override Switch 5 times, car lamp flashes 5 times, car horn honks 5 times, LED stays solid ON, indicating Factory Settings Mode.
*3.Press Override Switch ONCE to enter Dome Light Delay Setting (Car Horn honk ONCE) then press the transponder button to TOGGLE the feature ON/OFF. The LED flashes ONCE to indicate ON and flashes TWICE to indicate OFF.
*4.Refer to the Programming Table below for the number of Override Switch PRESS for each setting.
|
|
|
| |
 |
|
| RRC065A - Self-Programming - Garage Door Opener (USA - MARKET) |
* Key chain-sized remote learns from your garage door opener, so there's no need to program it manually.
* Conveniently programs Itself from your current garage door opener
* Works with 90% of Garage Door openers on the market
* Learns both fixed and multi-code systems for universal use
* Open two garage doors
* Comfortable ergonomic grip
* Uses one 12-V battery (Included)
** USA Market Version. * Fcc Approved
** Patented in USA, TAIWAN,And CHINA
*** OEM & ODM Customer: Brookstone |
|
|
| |
|
|
